Spyder MR6 - Eko Cup Seal Removal

9
EKO™ CUP SEAL REMOVAL
The following steps will provide easy access to the Eko™ Cup Seal. The sign of a worn out Eko™ Cup Seal is
the presence of CO2 / Compressed Air leaking down the barrel.
HELPFUL TIP: Do not rush or skip any of the steps for proper disassembly of the marker. Remove the barrel
before starting.
STEP 1. Using a 1/2 inch/13 mm open end or an adjustable wrench to loosen the swivel end of the Hose.
NOTE: A Plastic Washer is inside the female swivel end of the Hose. Make sure you do not lose this part.
STEP 2. Remove the three screws that hold the Trigger Frame to the Reciever. One screw is located at the rear
of the Trigger Frame. Two additional screws are on the left and right side of the Trigger Frame.
STEP 3. Remove the Vertical Screw that is holding the Reservoir Plug. Once the Reservoir Plug has been
removed the Valve Spring, Eko™ Valve Pin, Eko™ Cup Seal Guide and Eko™ Cup Seal will be attached.
STEP 4. Detach the Valve Spring from the Reservoir Plug, and then unscrew the Eko™ Cup Seal from the
Eko™ Valve Pin. Replace the Eko™ Cup Seal with a new one supplied in the Spare Parts Kit.
Once these steps have been completed, replace the damaged Eko™ Cup Seal and reassembly all parts back
in the Receiver. HELPFUL TIP: Please note how the parts are removed for easy reassembly.
CAUTION: Use the proper Allen wrenches to fasten all screws and never apply more force than necessary.
IMPORTANT: Always remove the Air Tank before any disassembly of your marker. Do not remove the Eko™
Valve Body unless specic Eko™ Valve Body repairs are needed. Do not remove the Eko™ Valve Body with a
screwdriver as it will damage the Eko™ Valve Body Lip.
Screw (65)
Screw (63)
Reservoir Plug (46)
Valve Spring (50)
Eko™ Cup Seal (51)
Eko™ Pin Valve (52)
Screw (30)
Swivel End (36)