26
Install
Einbauen
Instalación
Installer
Installare
Monteren
Instalar
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the eTap shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
Refer to pages 16-18 for bar extension
Blip installation.
Route the Blip wire from the bar
extension under the drop handlebar
and plug it into the shifter input 2.
1
Adjust Régler Ajustar
Einstellen Regolare
調節
Ajustar Afstellen
调节
2
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
Fold the hood back onto
the shifter.
NOTICE
Handlebar tape can be
wrapped over the Blip
button and wire.
To Next Page
Loading...
