SRAM RSC - Piston Assembly Installation

22Piston Assembly Installation
P iston Assembly Installation
NOTICE
DOT fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (i.e. your frame) or printing on the brakes, wipe it off
immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT fluid is not covered under warranty.
Submerge the new piston assembly in SRAM High-Performance
DOT 5.1 fluid.
You can also use SRAM DOT Assembly Grease, or DOT 5.1 or 4
compatible grease, as a lubricant.
Install the new lubricated piston assembly into the lever body.
Spray isopropyl alcohol on the lever body and both of your gloves and
clean with a rag.
Use the SRAM Guide™ Lever Internals Assembly Tool to press the
piston into the lever body while inserting the contact adjust knob into
the contact adjust slot.
You should hear a pop sound when the contact knob is fully seated in
place.
1
SRAM High-Performance DOT 5.1 Fluid Avid High-Performance 5.1 DOT Fluid 22 mm
2
3
SRAM Guide Lever Internals Assembly Tool Avid High-Performance 5.1 DOT Fluid 22 mm
SRAM Guide Lever Internals Assembly Tool Avid High-Performance 5.1 DOT Fluid 22 mm