Assembly/Changing the shift cable/Shift Adjustment
English Page 12
• Line up the ‘3’ gear number
mark with the indicator mark.
• From the edge (Fig. 5.), pull open
the cable change hatch.
• Remove and discard the rest of
the old cable.
• Feed the new cable through the
cable entry in the grip and out
through the barrel adjuster.
• Feed the cable through the new
cable housing and stops.
• Connect the shift cable to the
hub (see Assembly locating
sleeve).
• Push locating sleeve (2, Fig. 6)
onto small pull rod (3).
SHIFT ADJUSTMENT
• Place the shifter in gear position
"3". Move the crank to check that
the gear is engaged.
• Push locating sleeve (2, Fig. 6)
onto the small pull rod (3) until
the control cable is taut. Make
sure that you don't pull the indi-
cator chain out of the deflection
pulley (4).
CHECK
• Place shifter in gear position "1"
while moving the crank.
• Setting too loose: In gear posi-
tion "1" the pull rod can be pulled
out of the deflection pulley by
hand.
• Setting too tight: It is difficult to
place the shift lever in gear
position "1".
• If required, readjust the shift
mechanism.
21
3
5
4
6
To Next Page
Loading...
