SERVICE AND MAINTENANCE
13-23
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Higher amperage
HOW TO CHECK AND REPLACE FUSE
1. Turn off all electrical systems and remove the ignition key
from the key cylinder.
2. Open the fuse and relay box cover.
3. Locate the defective fuse.
4. Pull out the relevant fuse by using the fuse puller.
5. Visually check whether it is blown or not.
6. If normal, insert it to its original position.
7. If blown, check its capacity and replace it with the same
capacity.
Open
Specified amperage
• The use of anything other than the specified fuse could cause
damage to the electrical system and even cause a fire.
• The use of different types or different rating fuses could cause
damage to the electrical system and even cause a fire. Always
replace a fuse with the one with the same rating.
WARNING
The underhood fuse and relay box has some spare fuses. Refill
the fuses immediately as you use them. The fuse rating is indi-
cated on the upper surface of the fuse.
NOTE
Normal
13-Service and Maintenance.p65 2006-05-17, ¿ÀÈÄ 1:00Page 23 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
