6
GENERAL OPERATION
Turn Unit On/Off
Press the power ( ) button to turn the unit on or off.
Adjust Volume (VOL)
Rotate the VOL knob on the front panel or press the VOL+/- buttons on the remote control to
Change the Source (SRC)
Press the SRC button to switch between RADIO, DISC, USB, CARD and AUX-IN modes.
Reset System (RESET)
The RESET button is used to reset all parameters to factory default settings.
This function may be used when the LCD does not display normally or sound is distorted,
or when any of the controls are disabled. To reset your system,
press the REL button
to release the control panel from the chassis and remove the control panel. Next, use a thin
object with a pointed end to depress the RESET button, located behind the control panel on
the main chassis.
Adjust Menu Options (SEL)
• Press the SEL button repeatedly to cycle through the following adjustable audio
functions: VOL, BASS, TREBLE, BALANCE, FADER, EQ OFF, LOUD, DX and STEREO.
• Press and hold the SEL
Set the Clock (CLK)
1. To display clock time, press the CLK button.
2. To set clock time, press and hold the CLK button and the hour will
3. Press the I<< or >>I button or press the NEXT or PREV button to adjust the hour.
Press the I<< or >>I button or press the NEXT or PREV button to adjust the minutes.
4. Press the CLK button and the minutes will
5.
6.
During Bluetooth mode, the clock can not be adjusted.
button to access these additional functions: VOL (LAS/ADJ),
AREA EU/US, Clock 12/24, and BEEP ON/OFF.
To Next Page
Loading...
