Introduction
The EVALSP820-XS is an easy to use evaluation board for the STSPIN820, providing a compact solution to evaluate the
performance of the STSPIN820 stepper motor driver with minimal external equipment and without the need for extra
components.
The hardware is fully compatible with RepRAp Arduino Mega Poloulo Shield (RAMPS) or other similar Fused Filament
Fabrication (FFF) 3D Printing platforms, representing a very fast drop-in replacement of similar solutions. Contrary to most other
competitor solutions, the EVALSP820-XS helps customers to really exploit the benefits of working at high microstepping
resolution.
Getting started with the EVALSP820-XS evaluation board
UM2434
User manual
UM2434 - Rev 1 - June 2018
For further information contact your local STMicroelectronics sales office.
www.st.com
To Next Page
Need help?
General
