ST NUCLEO-F410RB - User Manual

August 2020 UM1724 Rev 14 1/68
1
UM1724
User manual
STM32 Nucleo-64 boards (MB1136)
Introduction
The STM32 Nucleo-64 boards based on the MB1136 reference board (NUCLEO-F030R8,
NUCLEO-F070RB, NUCLEO-F072RB, NUCLEO-F091RC, NUCLEO-F103RB,
NUCLEO-F302R8, NUCLEO-F303RE, NUC
LEO-F334R8, NUCLEO-F401RE,
NUCLEO-F410RB, NUCLEO-F411RE, NU
CLEO-F446RE, NUCLEO-L010RB,
NUCLEO-L053R8, NUCLEO-L073RZ, NUCLEO-L152RE
, NUCLEO-L452RE,
NUCLEO-L476RG
) provide an affordable and flexible way for users to try out new concepts
and build prototypes with the STM32 microcontrollers in the LQFP64 package, choosing
from the various combinations of performance, power consumption, and features. The
ARDUINO
®
Uno V3 connectivity support and the ST morpho headers provide an easy
means of expanding the functionality of the Nucleo open development platform with a wide
choice of specialized shields. The STM32 Nucleo boards do not require any separate probe
as they integrate the ST-LINK/V2-1 debugger and programmer. The STM32 Nucleo boards
come with the comprehensive free software libraries and examples available with the
STM32Cube MCU Packages, as well as direct access to the Arm
®
Mbed
™
online resources
at
http://mbed.org/ .
Figure 1. STM32 Nucleo-64 board
Picture is not contractual.
www.st.com

ST NUCLEO-F410RB Specifications

General

Microcontroller	STM32F410RB
Core	ARM Cortex-M4
Clock Speed	100 MHz
Flash Memory	128 KB
SRAM	32 KB
GPIO Pins	Up to 50
I2C	3
SPI	3
UART/USART	3
Operating Voltage	3.3 V
Debug Interface	SWD
USB	USB 2.0
DAC Channels	1
Timers	7 (16-bit and 32-bit)
Communication Interfaces	I2C, SPI, UART
Board Connectors	Arduino Uno V3, ST Morpho

Summary

Features

Core Board Features

Power Supply and Debugging Capabilities

Explains power options and the integrated ST-LINK/V2-1 debugger.

Ordering Information

Product Ordering Codes

Lists available STM32 Nucleo-64 boards and their references.

Development Environment Setup

System Requirements and Toolchains

Quick Start Guide

Initial Board Setup and Demo

Step-by-step instructions for initial board setup and running the demo.

Hardware Layout and Configuration

PCB Design and ST-LINK;V2-1 Integration

Details PCB features, pre-cut options, and the integrated ST-LINK/V2-1.

ST-LINK;V2-1 Features and Usage

Covers ST-LINK driver, firmware, programming, and debugging.

Power Supply Options and Management

Details USB, VIN, E5V, and +3.3V power inputs and management.

Clock Signal Configuration

Solder Bridge Configuration Options

ARDUINO Connector Pin Assignments

Lists pin mapping for ARDUINO Uno V3 connectors.

ST Morpho Connector Pin Assignments