ST NUCLEO-F439ZI User Manual

December 2017 DocID028599 Rev 7 1/82
1
UM1974
User manual
STM32 Nucleo-144 boards
Introduction
The STM32 Nucleo-144 boards (NUCLEO-F207ZG, NUCLEO-F303ZE, NUCLEO-F412ZG,
NUCLEO-F413ZH, NUCLEO-F429ZI, NUCLEO-F439ZI, NUCLEO-F446ZE,
NUCLEO-F722ZE, NUCLEO-F746ZG, NUCLEO-F756ZG, NUCLEO-F767ZI and
NUCLEO-H743ZI) provide an affordable and flexible way for users to try out new concepts
and build prototypes, by choosing from the various combinations of performance and power
consumption features provided by the STM32 microcontroller. The ST Zio connector, which
extends the Arduino
™
Uno V3 connectivity, and the ST morpho headers provide an easy
means of expanding the functionality of the Nucleo open development platform with a wide
choice of specialized shields. The STM32 Nucleo-144 boards do not require any separate
probe as they integrate the ST-LINK/V2-1 debugger/programmer. The STM32 Nucleo-144
boards come with the comprehensive free software libraries and examples available with
the STM32Cube MCU Package, as well as a direct access to the Arm
®
Mbed Enabled
™
on-
line resources at http://mbed.org.
Figure 1. Nucleo-144 board (top view) Figure 2. Nucleo-144 board (bottom view)
www.st.com
All manuals and user guides at all-guides.com
all-guides.com

ST NUCLEO-F439ZI Specifications

General

Brand	ST
Model	NUCLEO-F439ZI
Category	Motherboard
Language	English

Summary

Product Identification and Ordering

Getting Started with STM32 Nucleo-144

Initial Board Setup

Step-by-step guide to configure the Nucleo-144 board and launch the demonstration application.

Hardware Layout and Configuration Guide

Embedded ST-LINK/V2-1 Debugger

Details on the integrated ST-LINK/V2-1 for programming, debugging, and its new features.

ST-LINK/V2-1 Firmware Upgrade

Instructions for keeping the ST-LINK/V2-1 firmware up-to-date for optimal performance.

Programming On-Board STM32

Steps to program the STM32 microcontroller directly on the Nucleo-144 board.

Programming External STM32

Guidance on using the ST-LINK/V2-1 to program an external STM32 application.

Power Supply Options

Covers options for powering the board via USB, VIN, E5V, and +3.3V sources.

USB Power Input

Details power supply from the ST-LINK USB connector and associated jumper settings.

External Power Inputs

Describes how to connect external power sources (VIN, E5V, +3.3V) to the board.

USB OTG and Device Modes

Information on utilizing the USB OTG or device-full-speed communication capabilities.

Solder Bridge Configuration Guide

ST Zio Connector Pin Assignments

ST Morpho Connector Pin Assignments

Appendix B: Compliance and Regulatory Information