ST NUCLEO-WL55JC STM32WL - CN12 SMA connector; CN5, CN6, CN8, and CN9 ARDUINO Uno V3 connectors

Table 15. CN16 MIPI10 connector pinout (STDC14 pinout compatible)
Connector Pin number Description Pin number Description
CN16
1 - 2 -
3 VDD (3V3) 4 T_SWDIO (PA13)
5 GND 6 T_SWCLK (PA14)
7 KEY (connected to GND) 8 T_SWO (PB3)
9 - 10 T_JTDI (PA15)
11
GNDDetect (connected to GND through
a 100 Ω resistor)
12 T_NRST
13 T_VCP_RX (PA3 by default or PB7) 14 T_VCP_TX (PA2 by default or PB6)
7.3 CN12 SMA connector
CN12 50 Ω SMA connector is available on the STM32WL Nucleo-64 board.
Figure 22. CN12 SMA connector
By default, the output of the RF part is on the CN12 SMA connector.
Table 16. SMA connector pinout
Connector Pin number Description
CN12
1 RF path
2 GND
3 GND
4 GND
5 GND
7.4
CN5, CN6, CN8, and CN9 ARDUINO
®
Uno V3 connectors
The CN5, CN6, CN8, and CN9 ARDUINO
®
connectors (see Figure 23) are female connectors compatible with the
ARDUINO
®
standard. Most shields designed for ARDUINO
®
can fit with the STM32WL Nucleo-64 board.
The ARDUINO
®
connectors on the STM32WL Nucleo-64 board support the ARDUINO
®
Uno V3.
UM2592
CN12 SMA connector
UM2592 - Rev 1
page 33/49