6000 COUNTS DIGITAL MULTIMETER
2
• Protected electronic equipment.
• Equipment connected to (source) circuits in which measures are taken
to limit transient overvoltages to an appropriately low level.
• Any high-voltage, low-energy source derived from a highwinding
resistance transformer, such as the high-voltage section of a copier.
• Appliance, portable tools, and other household and similar loads.
• Outlet and long branch circuits.
• Outlets at more than 10 meters (30 feet) from CAT III source.
• Outlets at more that 20 meters (60 feet) from CAT IV source.
• Equipment in fixed installations, such as switchgear and polyphase
• Bus and feeder in industrial plants.
• Feeders and short branch circuits, distribution panel devices.
• Lighting systems in larger buildings.
• Appliance outlets with short connections to service entrance.
• Refers to the “origin of installation”; i.e., where low-voltage connection is
• Electricity meters, primary overcurrent protection equipment.
• Outside and service entrance, service drop from pole to building, run
• Overhead line to detached building, underground line to well pump.
* When using this Multimeter, the user must observe all normal safety rules concerning:
― protection against the dangers of electric current.
― protection of the Multimeter against misuse.
* For your own safety, only use the test probes supplied with the instrument. Before use, check that they are in good
To Next Page
Loading...