ST X-CUBE-MEMS1 - References; Figure 9. Datalog Window

Step 6. Click on the Datalog icon in the vertical toolbar to open the datalog configuration window: you can
select the sensor and fusion data to be saved in the files. Y
ou can start or stop saving by clicking on
the corresponding button.
Figure 9. Datalog window
2.4 References
All of the following resources are freely available on www.st.com.
1. UM1859: Getting started with the X-CUBE-MEMS1 motion MEMS and environmental sensor software
expansion for STM32Cube
2. UM1724: STM32 Nucleo-64 board
3. UM2128: Getting started with Unicleo-GUI for motion MEMS and environmental sensor software expansion
for STM32Cube
UM2220
References
UM2220 - Rev 7
page 19/24