Stack-On PFS-016-BG-E - Mark and Position Safe for Mounting; Drill Pilot Holes

PAGE 8 of 28 40721-1703
OWNER'S MANUAL
®
PERSONAL FIREPROOF SAFES

STEP 2
Posion the safe in
desired locaon.
Use a screw or pencil to mark the
4 mounng locaons on the
oor and wall.
NOTE: Make sure to mark
and secure to one wall stud
as shown.
Remove safe from marked locaon.
STEP 3
SECURING TO WOOD:
Using a 3/16" drill bit, drill a 2.5"
hole in marked locaon.
SECURING TO MASONRY:
Using a 3/8" drill bit, drill a 2.5" hole
in marked locaon.
WALL STUD
WALL STUD