Stack-On PS-1508 - BATTERY REPLACEMENT; Battery Type & Lifespan; KEYPAD SOUND CONTROL; On;Off Functionality

40531-1506
3
18
e safe must be mounted to a wall stud, and to a
permanent shelf or the oor. For optimal safety
and security, the safe should be installed in an
isolated, dry and secure area.
NOTE: Do not mix old and new baeries. Do not
mix alkaline, standard or rechargeable baeries.
is safe uses 4 - AA baeries. Under normal use,
baeries will last about 1 year.
NOTE: If the baeries are low, the yellow light will
ash when you start to enter your code.
To replace the baeries, open the baery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
baeries.
BATTERY REPLACEMENT
SECURING THE SAFE
SELECTING A LOCATION
TURNING THE KEYPAD SOUND
OFF/ON
Figure 1
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
NOTE ON LOCKING THE SAFE: e safe
needs to be in an upright position, as shown in
gure 1, for the locking mechanism to function
properly. Failure to mount the safe in the correct
upright position will compromise the safety and
security of the safe.
NOTE: is safe must be mounted to a wall
stud, and to a permanent shelf or the oor.
Failure to do so will compromise the safety and
security of the safe.
You can turn o the "Beep" sound of the keypad
by pressing the ... key.
To turn the "Beep" sound on, press the ....
key again.
PS-1520
PS-1508
PS-1514
PS-1515
PS-1415-RTX
Your safe comes with the "Beep" sound turned on.