Stamina 1735 - Storage Instructions; Folding and Moving the Power Tower; Maintenance Guidelines; Regular Inspection and Care

12
1. To store the Stamina® Full Body Power Tower 1735, simply keep it in a clean dry place.
2. Fold up the bench. Use two people to lift from the back of the BASES(1) and PULL-UP BAR(12) to
move the Stamina® Full Body Power Tower 1735.
3. You can fold up the bench to be the back cushion for VKR function, or for easy storage. Follow the
following process to fold the bench:
The safety and integrity designed into the Stamina® Full Body Power Tower 1735 can only be
maintained when the Stamina® Full Body Power Tower 1735 is regularly examined for damage and
wear. Special attention should be given to the following:
1. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
2. Verify that the CAUTION LABEL(40) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(40) if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components must be replaced immediately or the Stamina® Full Body Power
Tower 1735 removed from service until repair is made.
5. Only Stamina Products supplied components should be used to maintain/repair the Stamina® Full
Body Power Tower 1735.
6. Keep your Stamina® Full Body Power Tower 1735 clean by wiping it o󰀨 with an absorbent cloth
after use.
STORAGE
MAINTENANCE
15
11
16
3
14
15
3
14
3
3
11
a. Pull out the LOCKING BAR(11) from the UPRIGHTS(3).
b. Fold up the bench and lock in position by inserting the LOCKING BAR(11) through the holes in the UPRIGHTS(3)
and BENCH FRAME(14).
c. Pull out the PULL PIN(16) and swing down the BENCH SUPPORT(15). Lock the BENCH SUPPORT(15) in
position by inserting the PULL PIN(16) through one of the adjustment holes in the U bracket and the holes in
the BENCH SUPPORT(15).
A. B.