SET UP INSTRUCTIONS
7
Equipment Mat
Adjust the location of InMotion E1000 on the floor to make the InMotion E1000 sets on
the floor without rocking.
Grasp the REAR STABILIZER(2) to move the InMotion
E1000. Do not use the Pedal Arms
to move the InMotion
E1000. The Pedal Arms will move and may pinch your hand or fingers.
LEVELING:
MOVING:
Locate and read the WARNING LABEL(55) on the InMotion
E1000. Make sure that all users
read the WARNING LABEL(55).
CAUTION:
FUNCTION INSPECTION:
Visually inspect the InMotion E1000 to verify that assembly is as shown in the above illustration. Check
the function of the InMotion
E1000. Stand on the foot pedals. Slowly move your highest foot forward and
follow the natural path of the machine. Turn the crank slowly through one complete revolution to verify that
the drive train functions properly. Adjust the TENSION KNOB(21) and verify that it functions properly.
Place the InMotion
E1000 in the area where it will be used. It is recommended that the InMotion E1000
be placed on an equipment mat. The InMotion
E1000 is approximately 24 1/4" long x 17" wide x 11 3/8"
tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 4.5 feet long is required for safe
operation of the InMotion
E1000. Make sure that adequate space is available for access to and passage
around the InMotion
E1000.
To Next Page
Loading...
