ASSEMBLY INSTRUCTIONS
STEP 1
Unfold the BASE ASSEMBLY to an upright position by moving the FRONT FRAME(1) away from REAR
FRAME(2). Then push down on the middle of the two FOLDING LINKAGES(3) until they are fully
locked down.
STEP 2
Slide one PROTECTIVE COVER(21) onto each side of the BASE ASSEMBLY, and pull the covers
down until the bottom of the covers are slightly lower than the
FOLDING LINKAGES(3). Secure the
PROTECTIVE COVERS(21) to the FOLDING LINKAGES(3) with the SECURING STRAPS on the
bottom of the covers.
NOTE:
6
When the PROTECTIVE COVERS(21) are assembled correctly, the FOLDING LINKAGES(3)
should not be visible, and the INVERSION TABLE LOGO should be on the outside. Refer to the
illustration.
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at:
parts@staminaproducts.com
To Next Page
Loading...
