What to do if Standard Horizon Explorer GX1600E Transceiver blows fuse?
If your Standard Horizon Transceiver blows a fuse when connected to the power supply, the power wires may be reversed. Check the power cable for DC voltage and replace the fuse (6A 250V). Make sure the red wire is connected to the positive (+) battery post, and the black wire is connected to the negative (–) battery post. If the fuse continues to blow, contact your Dealer.
Why does my Standard Horizon Explorer GX1600E show 'HI BATTERY' or 'LO BATTERY'?
If your Standard Horizon Transceiver displays a “HI BATTERY” or “LO BATTERY” message when powered on, it means the power supply voltage is either too high or too low. Verify that the connected power supply voltage is not above 17 volts or below 10 volts.
How to fix Standard Horizon Explorer GX1600E Transceiver that fails to power up?
If your Standard Horizon Transceiver isn't powering up, the cause might be no DC voltage to the transceiver or a blown fuse. First, check the 12VDC battery connections and the fuse. Also, ensure that you press and hold the power key to turn the radio on.
How to eliminate noise from Standard Horizon Explorer GX1600E Transceiver speaker?
If you're hearing popping or whining noises from the speaker of your Standard Horizon Transceiver while the engine is running, it's likely due to engine noise. Try these solutions: * Re-route the DC power cables away from the engine. * Add a noise suppressor on the power cable. * Change to resistive spark plug wires and/or add an alternator whine filter.
Why Standard Horizon Explorer GX1600E has low transmit power?
If a receiving station reports low transmit power from your Standard Horizon Transceiver, even when set to HI power, the issue might be with the antenna. Have the antenna checked or test the transceiver with another antenna. If the problem persists, contact your Dealer for servicing.
What to do if Standard Horizon Transceiver position is not displayed?
If your position is not displayed on your Standard Horizon Transceiver, there could be a couple of reasons. First, check the accessory cable connection. Some GPS Chart Plotters use the battery ground for NMEA connection. Also, check the output signal format of the GPS Chart Plotter. This radio requires NMEA0183 format with GLL, RMB, or RMC sentence as an input signal. If the GPS has a baud rate setting make sure to select 4800 and parity to NONE.
Why Standard Horizon Explorer GX1600E Transceiver sound is not emitted?
If sound is not emitted from the internal or external speaker of your Standard Horizon Transceiver, the issue might be with the accessory cable. Check the connections of the accessory cable. It could also be that the external speaker cable (WHITE/SHIELD) is shorted together.
Provides steps for making a Mayday call on Channel 16.
Explains antenna and power supply connections, including voltage requirements.
Explains what an MMSI is and its importance for DSC.
Step-by-step guide to inputting the MMSI number into the radio.
Detailed procedure for sending a DSC distress alert.
How to include the nature of distress in an alert.
Steps to transmit a call to all ships, designating urgency or safety.
How to set up the directory for individual calls and position requests.
Procedure for initiating an individual call using the directory.
Procedure for setting up group MMSI for group calls.
How to initiate a group call using the directory.
How to configure automatic or manual sending of vessel position.
How to request another vessel's position.
How to send your vessel's position report.
How to perform a DSC test call using the individual directory.
General| Brand | Standard Horizon |
|---|---|
| Model | Explorer GX1600E |
| Category | Transceiver |
| Language | English |
To Next Page