GX2360SPage 60
9.3 PA/FOG OPERATION
When the RAM+ is connected to the QUANTUM it is capable of controlling the
30W Public address, 4 fog horns, bells, and whistles.
9.3.1 Operating the PA / Hailer
1. Press and hold the
[
NAV
]
key then select PA with the
[
]
or
[
]
key.
2. Press the
[
CALL/SET
]
key.
3. Press the PTT switch and speak into the microphone.
4. To turn up the PA Volume, press the PTT switch and press
the
[
]
or
[
]
keys to adjust the Audio output level. The
level can be set from 0 to 30W.
5. To adjust the listen back volume, (while in listenback mode)
press the
[
VOL
]
Key, then press the
[
]
or
[
]
key to the
desired listen back volume.
To exit from the PA Hailer mode, press the
[
CALL/SET
]
,
[
16/9
]
,
or
[
WX
]
key.
9.3.2 Operating the FOG Horn
The QUANTUM is capable of sending 4 pre-programmed fog signals and also
Horn, Siren, Aground and Anchor signals.
FOG 1: POWER BOAT UNDERWAY
FOG 2: POWER BOAT STOPPED
FOG 3: SAIL BOAT, FISH VESSEL, TOW VESSEL
FOG 4: VESSEL UNDER TOW
1. Press and hold the
[
NAV
]
key then select FOG with the
[
]
or
[
]
key.
2. Press the
[
CALL/SET
]
key.
3. Select the one of the eight functions described above with
the
[
]
or
[
]
key and press the
[
CALL/SET
]
key.
4. On the “Horn” and “Siren” modes, press the PTT switch to
activate the tone through the HAIL/PA speaker.
Press the
[
]
or
[
]
keys to adjust the Audio output level.
The level can be set from 0 to 30W.
5. To adjust the listen back volume, (while in listenback mode)
press the
[
VOL
]
Key, then press the
[
]
or
[
]
key to the
desired listen back volume.
To exit from the FOG or other signaling mode, press the
[
16/9
]
,
[
WX
]
, or
[
CALL/SET
]
key.
Need help?
General
