StandDesk PRO - Assembly Step 2: Attaching Support Braces; Secure Braces to Legs; Assembly Step 3: Adjusting Middle Slat; Slat Width Adjustment

STEP 3
Find the middle slat. Loosen but don’t remove the pre-installed
bolts. Adjust the width of the slat by pulling each end away from
each other.
STEP 2
Attach a support brace to each leg using four M6x12 anti-slip
bolts. Ensure the flat side is touching the desktop.
H7
1
1
1
!
Match up the triangles so they kiss