Need help?Do you have a question about the StandDesk PRO and is the answer not in the manual?
General| Brand | StandDesk |
|---|---|
| Model | PRO |
| Category | Indoor Furnishing |
| Language | English |
Ensure clear space around the desk and check cord length for height adjustments.
Keep hands and fingers clear to avoid injury.
Keep children away; avoid liquids and opening components.
Describes intended use and disclaims responsibility for damages from improper handling.
List of tools needed for assembly.
Identifies all desk parts and their quantities.
Lists all screws, bolts, and washers.
Visual representation of all parts with labels and quantities.
Details like height range, weight capacity, and duty cycle.
Align support braces with pre-drilled holes on StandDesk tops for easier assembly.
Attach support braces to legs using M6x12 bolts, flat side against desktop.
Loosen bolts and adjust the middle slat's width.
Align and attach middle slat to legs using M6x35 bolts.
Place stabilizing foot plates onto each leg.
Attach feet to foot plates using M6x12 bolts.
Attach tray to back middle slat using M6x12 bolts and washers.
Loosen crossbar bolts and adjust width.
Attach crossbar to legs using M6x25 bolts.
Secure control box to holder using inserts.
Attach control box holder to front middle slat.
Attach frame to desktop using ST 4.8x16 screws.
Use drill for tops without pre-drilled holes.
Attach handset to desktop using ST 3.5x16 screws.
Connect handset and extension cords to control box.
Connect each leg motor to the control box via extension cords.
Tighten bolts and carefully flip the desk onto its feet.
Caution to avoid damaging the handset during flipping.
Plug in the desk and ensure no obstacles for movement.
Hold down button until desk reaches lowest position.
Instructions apply to both handset types.
Congratulations on finishing the assembly.
Identifies buttons for settings, menu, and movement.
Press any button to activate the desk.
Procedure to calibrate or reset the desk.
Explains common error codes (GLP, CON, HIT, OH, OLU) and resolutions.
Save desired heights using 'M' and save button.
Set maximum and minimum height limits.
Adjust maximum and minimum load capacity.
Switch between inches and centimeters.
Adjust collision sensitivity level.
To Next Page
