To Next PageTo Next Page
Need help?Do you have a question about the Standex Master-Bilt M-SERIES and is the answer not in the manual?
Critical notices on qualified personnel, grounding, and manual usage.
Procedure for inspecting shipments for damage and filing claims.
Guidelines for safely handling and positioning condensing units.
Guidelines for safely handling and positioning evaporator coils within walk-ins.
Matching power supply to unit requirements and field wiring procedures.
DANGER: Installation must be by qualified personnel to prevent injury or death.
Use of correct tubing and keeping lines clean and dry.
Guidance on selecting liquid line size based on defrost method.
Proper suction line slope and installation of oil traps.
Using dry nitrogen during brazing and minimizing flux use.
Using a two-stage vacuum pump and electronic indicator for dehydration.
Detailed steps for evacuating the system to the required micron level.
Initial checks before charging, including valve positions and fan operation.
Refrigerant addition for M-Series units without head pressure control.
Refrigerant addition for B-Series units with head pressure control.
DANGER: Charging must be by certified mechanics to prevent injury or death.
Positioning the evaporator coil for proper air flow and load distribution.
Locating the condensing unit for unrestricted airflow.
Checking high-low pressure controls and defrost timer settings.
Verifying operating pressures and electrical requirements.
Setting temperature controls and checking TXV for proper operation.
Checking sight glass for refrigerant charge and compressor oil level.
Checking defrost, vibration, opening valves, and packing nuts.
General| Cooling Capacity | Varies by model (See Product Catalog) |
|---|---|
| Heating Capacity | Varies by model (See Product Catalog) |
| Sound Level | Varies by model (See Product Catalog) |
| Dimensions (H x W x D) | Varies by model (See Product Catalog) |
| Weight | Varies by model (See Product Catalog) |
