Standex MHHX035CC - User Manual

5/16 Rev. B 57-02497
Condensing Unit and
Refrigeration System
Installation & Operations Manual
908 Highway 15 North
New Albany, MS 38652
Phone: 800-684-8988
Fax: 800-232-3966
www.master-bilt.com
©2015 Master-Bilt Products, an unincorporated division of Standex International Corporation.
All rights reserved.

Summary

Safety and Warning Information

Notice to Employers

Important safety responsibility for those who install, use, or service equipment.

Master-Bilt Refrigeration Model Nomenclature

Pre-Installation Procedures

General Information

Initial guidance before installing Master-Bilt refrigeration equipment.

Delivery Inspection

Procedure for inspecting units upon delivery for damage or shortages.

Installation Instructions - Unit Placement

Condensing Unit Handling and Placement

Guidelines for safely handling and positioning condensing units.

Evaporator Coil Handling and Placement

Guidelines for safely handling and positioning evaporator coils.

Evaporator Drain Line Installation

Electrical Installation Requirements

Refrigerant Piping Guidelines

Leak Check Procedure

System Evacuation, Dehydration, and Start-Up

Evacuation Procedure

Step-by-step guide for evacuating the refrigeration system.

Finish Charging Procedures

Preliminary Charging Steps

Initial checks and preparations before charging refrigerant.

Remote M-Series Charging

Specific refrigerant charging instructions for M-Series units.

Built-Up Remote B-Series Charging

Pre-Charged Remote System Installation

Final System Check List

Pressure and Defrost Settings

System Operating Parameters

R-404 A Suction and Liquid Line Sizing

Equivalent Length Allowance for Fittings

Low Ambient Operation Charge

Condensing Unit Specifications - B-Series Models

Standex MHHX035CC Specifications

General

Brand	Standex
Model	MHHX035CC
Category	Heat Pump
Language	English