To Next PageTo Next Page
Need help?Do you have a question about the Stanley 51186 and is the answer not in the manual?
General| Brand | Stanley |
|---|---|
| Model | 51186 |
| Category | Remote Control |
| Language | English |
Plug the receiver unit into a power outlet to begin the setup process.
Press and hold the receiver's power button for 5 seconds until the LED flashes slowly.
Press the transmitter's 'ON' button followed by the 'OFF' button to complete pairing.
Press and hold the receiver power button for 5 seconds until the LED indicator flashes slowly.
While the LED flashes slowly, press and hold the power button for another 5 seconds until it flashes rapidly.
Press the receiver power button once while the LED flashes rapidly to confirm the reset.
Turn power ON/OFF manually with transmitter. Power stays ON until OFF is pressed.
Set switch to PHOTOCELL. Turns ON automatically, OFF at dawn.
Press receiver button to override programs. Do not hold to avoid pairing mode.
