To Next PageTo Next Page
Need help?Do you have a question about the Stanley W31166 and is the answer not in the manual?
General| Brand | Stanley |
|---|---|
| Model | W31166 |
| Category | Remote Control |
| Language | English |
Connect the receiver to a power outlet to initiate the setup process.
Hold the receiver's power button for 5 seconds until the LED flashes slowly.
Press the transmitter's 'ON' button, followed by the 'OFF' button, to finalize pairing.
Press and hold the receiver's power button for 5 seconds until the LED indicator flashes slowly.
While the LED flashes, hold the power button for an additional 5 seconds until it flashes rapidly.
Press the receiver's power button once to confirm the reset process.
Summary of how to reset the receiver and remove all paired transmitters.
Article number, copyright, manufacturer, and website contact information.
