To Next PageTo Next Page
Need help?Do you have a question about the Stanley SK262 and is the answer not in the manual?
General| Brand | Stanley |
|---|---|
| Model | SK262 |
| Category | Remote Control |
| Language | English |
Plug the receiver into a grounded outlet before pairing.
Press and hold the receiver power button for 5 seconds to start pairing.
Press transmitter ON then OFF buttons to finish the pairing procedure.
Press and hold the receiver power button for 5 seconds to begin removal.
Press and hold the receiver power button for another 5 seconds to flash rapidly.
Press the receiver power button once to confirm the transmitter reset.
Manually control the unit ON/OFF using the receiver's front button.
Device automatically turns OFF at dawn when photocell mode is active.
