Stanley FMC620 User Manual

11
T
HE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Stanley FatMax.
RBRC™ in cooperation with Stanley FatMax and other battery users, has
established programs in the United States to facilitate the collection of spent lithium-ion
batteries. Help protect our environment and conserve natural resources by returning the
spent lithium-ion battery to an authorized Stanley FatMax service center or to your local
retailer for recycling. You may also contact your local recycling center for information on
where to drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
•Unit will not start. •Battery pack not installed properly. •Check battery pack
installation.
•Battery pack not charged. •Check battery pack
charging requirements.
•Battery pack will not charge. •Battery pack not inserted into charger. •Insert battery pack into
charger until LED
appears.
•Chargernotplugged in. •Plug charger into a
working outlet. Refer to
“Important Charging Notes”
for more details.
•Surrounding air temperature •Move charger and battery
too hot or too cold. pack to asurrounding air
temperatureof above 40
degrees F (4,5°C) or below
105 degrees F(+40,5°C).
SPECIALNOTES FOR USE WITHLITHIUM BATTERIES
•Unit shuts off abruptly. •Battery packhas reachedits •Allow batterypack to cool
maximum thermal limit. down.
•Out ofcharge. (To •Place on charger and
maximize the life of the allow to charge.
batterypackitisdesigned
to shutoff abruptly when
the charge isdepleted.)
For assistance with your product, visit our website at www.stanleytools.com. for a list of
service centers, or call the Stanley FatMax Customer Care Center at (800) 262-2161
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

Stanley FMC620 Specifications

General

Brand	Stanley
Model	FMC620
Category	Drill
Language	English