ID07 User Manual ◄ 15
• Make sure all couplers are wiped clean before
connection.
• The hydraulic circuit control valve must be in
the “OFF” position when coupling or uncoupling
hydraulic tools. Failure to do so may result in damage
to the quick couplers and cause overheating of the
hydraulic system.
• Always store the tool in a clean dry space, safe from
damage or pilferage.
• Make sure the circuit PRESSURE hose (with male
quick disconnect) is connected to the “IN” port. The
circuit RETURN hose (with female quick disconnect)
is connected to the opposite port. Do not reverse
circuit ow. This can cause damage to internal seals.
• Always replace hoses, couplings and other parts
In addition to the Safety Precautions found in
this manual, observe the following for equipment
protection and care.
with replacement parts recommended by STANLEY.
Supply hoses must have a minimum working
pressure rating of 2500 psi/172 bar.
• Do not exceed the rated ow. See “Specications” on
page 17 for correct ow rate and model number.
Rapid failure of the internal seals may result.
• Always keep critical tool markings, such as warning
stickers and tags, legible.
• Tool repair should be performed by experienced
personnel only.
• Make certain that the recommended relief valves
are installed in the pressure side of the system.
• Do not use the tool for applications for which it was
not intended.
TOOL PROTECTION & CARE
IMPACT MECHANISM MAINTENANCE
If your ID07 shows or starts to show signs of reduced or low pow-
er, it could be a result of lack of grease in the impact mechanism.
To correct this do the following:
1. Remove the impact
mechanism by removing the 3
capscrews holding it on.
2. With the impact mechanism held
in the palm of your hand ( 3 holes
in hammer case facing down), lift
o and remove the hammer case
along with the anvil leaving just the
hammer frame, hammers and pins
left in the palm of your hand.
3. Fill up the cavity hole
completely with grease (see g
3) and then put back together
the hammer case and anvil.
Note some grease will extrude
out the end of the hammer
frame.
4. Install the complete impact mechanism back
onto the main housing assembly using the 3
capscrews.
Type of Grease:
Mobile Delvac Xtreame (Premium
Lithium Complex Grease) or equivalent.
To Next Page
Loading...
