ID07 User Manual ◄ 17
Drive Size ...................................................................................................... 1/2 inch Square Drive or 7/16 inch Hex
Weight .....................................................................................................................................................7 lbs / 3.3 kg
Overall Length .......................................................................................................................................9 inch / 23 cm
Width .....................................................................................................................................................5 inch / 11 cm
Height ............................................................................................................................................10.5 inch / 26.7 cm
Motor ...............................................................................................................................................................Integral
Pressure Range.............................................................................................................................. 2000 psi / 140 bar
Flow Range .......................................................................................................................... 4–12 GPM / 15–45 LPM
System Type .................................................................................................Open and Closed Center, HTMA Type II
Porting ...................................................................................................................................................-8 SAE O-ring
Output Torque ................................................................................................................................ 500 ft lbs / 675 Nm
Connect Size and Type ....................................................................................................... 3/8 inch NPT Pipe Fitting
SOUND AND VIBRATION DECLARATION
Test conducted on ID07.
Measured A-weighted sound power level, Lwa (ref. 1pW) in decibels 101.1 dBA
Uncertainty, Kwa, in decibels 3.39 dBA
Measured A-weighted sound pressure level, Lpa (ref. 20 µPa) at operator’s position, in decibels 93.1 dBA
Uncertainly, Kpa, in decibels 3.39 dBA
Values determined according to noise test code given in EN ISO 15744, 11203 and 3744.
Note: The sum of a measured noise emission value and its associated uncertainty represents
an upper boundary of the range of values which is likely to occur in measurements.
Declared vibration emission value: A 8.5 m/sec
2
Uncertainty: K 1.74 m/sec
2
Values determined according to EN ISO 28927-2
SPECIFICATIONS
To Next Page
Loading...
