Stanley P1800S - Preparation and Assembly (P1450 S Series); Surface Preparation Steps

PREPARATION& ASSEMBLY- Model P1450S,P1450S-CAN,P1600S,P1600S-BB,P1600S-CAN
Assembly Time: 5 minutes
Tools Required: 17mmor Adjustable Wrench
SurfacePreparation
• Beforestartinganycleaningtask,it is importantto inspectthe area
for objectswhichcouldcreatea hazard.
• Removeanyobjectsfromthework areawhichcouldbetripped
over,suchastoysor outdoorfurniture.
• Ensurethat all doorsandwindows areclosedtightly.
Step 1
• Removeorpeeloff blueprotectivefilm ontile front ofthe pressure
washerandonthewands(if applicable).Also, removeanybubble
wrap. Discardblueprotectivefilm andbubblewrap.
Step 2
• Attachtile QuickConnectInletcouplingto watersupplyinlet on
pressurewasher,asshownin Figurebelow.
Step 5
• AttachotherendofHighPressureHoseto Gunasshownin Figure
below. Fastentightlywith 17mmwrenchto avoidleakage.
Step 6
• AttachShoulderStrapto tile StrapBracketas shownin Figure
below.
Step 3
• Attach WandBracketto tile unit asshowninFigurebelow.
Step 7
• Attachtile hoseholderstraptotile sideof tile unit asshownin
Figurebelow.
Step4
• Attach HighPressureHoseto MainUnitas shownin Figurebelow.
For Operating Instructions, proceed to page 9.
{m
8of18 STANLEYi Electric PressureWashers Rev:Feb2011