Stanley PB2500 - Operation Test and Appearance Check

26
ENGLISH
Tighten SA Nose housing onto the
thread of Mast housing by hand.
9. Operation Test and Appearance check
Operation Check
Set 20 rivets of 4.8mm (3/16”) Stainless
rivet and 10 Aluminum rivet to check
followings:
 The tool(Jaws) does not slip.
 Rivet setting is done in one stroke.
 There are no protruding mandrels.
 There is no abnormal noise.
 The next rivet introduced to the front
of the tool is inserted smoothly.
 The jaws do not bite.
 The waste mandrel is ejected to the
Collector correctly.
 The collector shutter operates
normally
(Open → Close)
Appearance check
 Any scratches on the housings
 Loose components and screws
 Any oil spots on the housings
 Peeling of the outer mold
(Rubber grip)
SA Nose housing
Mast housing