Stanley PB2500 - Restoring to Factory Settings

27
ENGLISH
10. Restoring to factory settings
If the tool does not operate or does not operate correctly or the screes freezes and
if the issue cannot be resolved by removing and re-attaching the battery, you can
restore the tool to factory settings.
If the power is on, remove the battery.
Re-attach the battery and pull the
trigger to turn on the power.
Touch 1. Upper left, 2. Upper right, 3.
Lower left in the screen in order during
showing Logo of Stanley Engineered
Fastening for a few seconds.
It is rebooted with the settings
restored to factory settings. If it fails,
try again.
*Counter value are not restored in this
procedure.
After restoring to factory, the data in a
memory on the tool must be reset.
If the backup is needed, touch “No”
and be back to “19. Extracting the
data” and copy the data required
before clearing the data.
Delete the data referring to “20.
Deleting the data”
Remove the battery to turn off the power.
*After restoring process, turn off the power surely. The tool may not operate correctly.
*Refer to TRM00952 Smart Touch Screen Instruction Manual for detail.
Extracting the data
Deleting the data
1
2
3