Stanley SCD20 User Manual

11
ENGLISH
(Original instructions)
Drilling in wood
Holes in wood can be made with the same twist drill bits
used for metal or with spade bits. These bits should be
sharp and should be pulled out frequently when drilling to
clear chips from the flutes.
Drilling in metal
Use a cutting lubricant when drilling metals. The exceptions
are cast iron and brass which should be drilled dry. The
cutting lubricants that work best are sulfurized cutting oil or
lard oil.
LED work light
When drill is activated by pulling the trigger switch (1), the
integrated LED work light (8) will automatically illuminate the
work area.
Note: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Bit tip storage
A bit storage slot (9) is built into the base of the tool.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
@
Important! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this
manual) should be performed by authorized
service centers or other qualified organiza-
tions, always using identical replacement
parts. Unit contains no user service able
parts inside.
ACCESSORIES
@
Warning! Since accessories, other than
those offered by STANLEY have not been
tested with this product, use of such acces-
sories with this tool could be hazardous.
To reduce the risk of injury, only STANLEY
recommended accessories should be used
with this product.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you nd one day that your STANLEY
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
STANLEY provides a facility for the collection
and recycling of STANLEY products once they
have reached the end of their working life. To
take advantage of this service please return
your product to any authorised repair agent
who will collect them on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your
local STANLEY office at the address indicated
in this manual. Alternatively, a list of authorised
STANLEY repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
BATTERIES
STANLEY batteries can be recharged many times.
At the end of their useful life, discard batteries with
due care for our environment:
fRun the battery down completely, then remove
it from the tool.
fNiCd, NiMH and Li-Ion batteries are recyclable.
Take them to any authorized repair agent or a local
recycling station.
REMARKS
Stanley's policy is one of continuous improvement to our
products and as such, we reserve the right to modify product
specifications without prior notice.
• Standard equipment and accessories may vary by
country.
• Product specifications may differ by country.
• Complete product range may not be available in all
countries. Contact your local Stanley dealers for range
availability.

Stanley SCD20 Specifications

General

Brand	Stanley
Model	SCD20
Category	Drill
Language	English