7
ENGLISH (Original Instructions)
Cable length (m)
7.5 15 25 30 45 60
Voltage Amperes Cable rated current (Ampere)
110-127 0 - 2.0 6 6 6 6 6 10
2.1 - 3.4 6 6 6 6 15 15
3.5 - 5.0 6 6 10 15 20 20
5.1 - 7.0 10 10 15 20 20 25
7.1 - 12.0 15 15 20 25 25 -
12.1 - 20.0 20 20 25 - - -
220-240 0 - 2.0 6 6 6 6 6 6
2.1 - 3.4 6 6 6 6 6 6
3.5 - 5.0 6 6 6 6 10 15
5.1 - 7.0 10 10 10 10 15 15
7.1 - 12.0 15 15 15 15 20 20
12.1 - 20.0 20 20 20 20 25 -
LABELS ON TOOL
The label on your tool may include the following symbols:
must read the instruction manual before use.
WARNING! To reduce the risk of injury, the
user
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
V Volts Direct Current
A Amperes n
0
No-Load Speed
Hz Hertz Class II
Construction
W Watts Earthing
Terminal
min minutes Safety Alert
Symbol
Alternating
Current
/min. Revolutions or
Reciprocation
per minute
Position of date code
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
2017 XX JN
Year of manufacturing
THE PACKAGE CONTAINS
1 1/4 Sander
1 Punch plate
1 Dust bag
1 Instruction manual
1 Warranty card
1 Service center list
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (FIG. A)
WARNING: Never modify the power tool or
any part of it. Damage or personal injury could
result.
1. On/off switch
2. Dust bag
3. Sanding base
4. Paper clamp lever
5. Punch plate
6. Dust bag collar
7. Dust extraction outlet
ASSEMBLY AND ADJUSTMENT
WARNING: To reduce the risk of serious
personal injury, turn tool off and disconnect
tool from power source before making any
adjustments or removing/installing attachments
or accessories. Before reconnecting the tool,
depress and release the trigger switch to ensure
that the tool is off. An accidental start-up can
cause injury.
Dust extraction (Fig. B)
WARNING: Since woodworking with a sander
produces dust, always install a dust bag
designed in compliance with the applicable
directives regarding dust emission.
WARNING: Do not use a dust bag or vacuum
extractor without proper spark protection when
sanding metal.
Your sander has a dust extraction methods: a built-in
outlet (7) which allows either the supplied dust bag (2) or a
shop vacuum system to be connected.
To attach the dust bag
• While holding the sander, fit the dust bag collar(6) to the
outlet (7) as shown in Figure C.
• Turn the collar (6) anticlockwise to lock the dust bag (2)
in place.
To Next Page
Loading...
