ENGLISH • 29
TROUBLE SHOOTING
PROBLEMA CAUSA POSIBLE SOLUCIÓN POSIBLE
Saw makes unsatisfactory cuts
Gum or pitch on blade
Remove blade and clean with
turpentine and coarse steel wool or
household oven cleaner.
Incorrect blade for work being done Change the blade
Blade does not come up to speed
Extension cord is too light or too long. Replace with adequate size cord
Low house current. Contact your electric company
Machine vibrates excessively
Saw not mounted securely Tighten all mounting hardware.
Stand or bench on uneven floor Reposition on flat level surface
Damaged saw blade Replace blade
Machine vibrates excessively
Miter scale not adjusted correctly Check and adjust.
Blade is not square to fence Check and adjust.
The blade is not perpindicular to the
table.
Check and adjust the guide.
Workpiece moving
Clamp workpiece to fence or glue 120
grit sandpaper to fence with rubber
cement.
Material pinches blade
Cutting bowed material.
osition bowed material as shown in
Fig. K.
To Next Page
Loading...
