TT46 User Manual ◄ 11
In addition to the Safety Precautions found in
this manual, observe the following for equipment
protection and care.
• Make sure all couplers are wiped clean before connection.
• The hydraulic circuit control valve must be in the “OFF” position when coupling or uncoupling hydraulic tools.
Failure to do so may result in damage to the quick couplers and cause overheating of the hydraulic system.
• Always store the tool in a clean dry space, safe from damage or pilferage.
• Make sure the circuit PRESSURE hose (with male quick disconnect) is connected to the “IN” port. The circuit
RETURN hose (with female quick disconnect) is connected to the opposite port. Do not reverse circuit ow.
This can cause damage to internal seals.
• Always replace hoses, couplings and other parts with replacement parts recommended by Stanley Hydraulic
Tools. Supply hoses must have a minimum working pressure rating of 2500 psi/172 bar.
• Do not exceed the rated ow. See “SPECIFICATIONS” on page 15 for correct ow rate and model number.
Rapid failure of the internal seals may result if improper ow is used.
• Always keep critical tool markings, such as warning stickers and tags, legible.
• Tool repair should be performed by experienced personnel only.
• Make certain that the recommended relief valves are installed in the pressure side of the system.
• Do not use the tool for applications for which it was not intended.
TOOL PROTECTION & CARE
To Next Page
Loading...
Need help?
General