cut for scratching and cutting to a longer fade for mixing.
21. Crossfader Reverse: Reverses the direction of the crossfader.
22. Power switch: Selects power "ON" or "OFF".
23. Microphone input: 1/4” connector
24. Channel 1 inputs: Line and phono signal inputs
25. Channel 2 inputs: Line and phono signal inputs
26. Ground connector: Connects to the turntable ground connector to eliminate electrical
hum. Ground connectors usually supplied with turntables
27. Master output: TRS balanced (1/4”) and unbalanced RCA.
28. Power supply connector: Input connection for the accompanying power supply.
Audio signal inputs/outputs:
Line inputs are used to connect to line level sources
such as CD players, samplers, tape players, etc. Phono inputs are used to
connect to turntables. Master output connects to an amplifier, EQ, crossover,
or other outboard signal processing. Record out connects to tape recorder,
mini disk recorder, etc.
TE C H N I CA L S P E C I FI C AT I O N S
Line inputs: 2 (RCA), 150 mV / 27K ohm
Phono inputs: 2 (RCA), 3 mV / 47K ohm
DJ mic input: 1 (1/4 inch), 2.45 mV / 3K ohm
Master output: 1 (1/4” TRS Balanced/RCA unbalanced),
775 mV / 1K ohm
Record output: 1 (RCA), 245 mV / 10K ohm
Headphone output: 1 (1/4 inch), 32 - 200 ohms recommended
Frequency Response: 20 Hz - 20 kHz, +/- 2 dB
Tone Control : + 9/-26 dB (Hi, Mid, Low)
Mic Tone: Hi/Mid/Lo +/-12 dB
Gain Control: 0-20dB
S/N Ratio: Less than 70dB
T.H.D: less than 0.2%
Dimension(LxWxD): 12
3/8
” x 10
1/4
” x 4” ( 314 x 260 x 102 mm)
Weight: 7 lbs (3.2 Kg)
WA R R A N T Y
This unit has been designed and manufactured using quality
components. Therefore, it is warranted to be free from defects in materi-
als (limited as specified below), and workmanship for a period of twelve
(12) months from the original purchase date. During this period, all
service and parts necessary to repair a defect will be free of charge. This
limited warranty applies to mechanical parts which are subject to wear
and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from
defects in materials and workmanship for a period of thirty days (30)
days from the original purchase date.
FOR THE WA R R A N T Y TO BE VA LID, PLEASE CO M PLE TE THE
O N LINE WA R R A N T Y REGIST R ATION FORM FOUND AT
W W W. STA N TO N M AG N E TI CS . CO M
2821 Evans Street • Hollywood, FL 33020
FU N C TI O N S ( c o n t ’d)
To Previous Page
Loading...
