Star Micronics TUP592 - Paper Guide Setting; Handling Specific Paper Widths

3.0.2.2. A is a reference for the paper roll holder unit paper roll shaft position. Adjust or mount the paper roll holder unit for the
core diameter and width of the paper you intend to use.
3-1 Handling 82.5 mm Paper Width
See Fig. 3.4.2.2.B for the paper roll holder setting position to handle paper widths of 82.5 ±0.5 mm.
Position the roll paper holder edge at position scale c.
See the figure to assembly at the correct position.
Note 1) The paper roll holder is assembled to that position when shipped from the factory.
3-2 Handling 79.5 mm Paper Width
See Fig. 3.4.2.2.C for the paper roll holder setting position to handle paper widths of 79 ±0.5 mm.
Position the edge of the paper roll holder at position scale c
3-3 Handling 57.5 mm Paper Width
See Fig. 3.6.2.2.D for the paper roll holder setting position to handle paper widths of 57.5 ±0.5 mm.
Position the edge of the paper roll holder at position scale b
3-4 Handling 45 mm Paper Width
See Fig. 3.6.2.2.E for the paper roll holder setting position to handle paper widths of 45 ±0.5 mm.
Position the edge of the paper roll holder at position scale d