Star Micronics TUP592 - Assembly - Paper Roll Setup

Assembly – Paper Roll Setup
It is necessary to adjust the paper roll holder for the width of the paper you use. If the setting position is incorrect, the paper roll will
be supplied improperly to the mechanism which in turn causes paper transport problems. Thus, it is should be properly adjusted.
The following table shows the paper roll holder
and paper core inner diameter range.
Paper roll Holder
Types
Paper Core
Diameter Ranges
Paper roll Holder (1)
25.4 mm ± 1
Paper roll Holder (2)
50.8 mm ± 1
Paper roll Holder (3)
Optional
76.2 mm ± 1
Note 1) The unit is assembled for 1 inch paper cores
when shipped from the factory. Also, it is set for a
paper width of 82.5 ±0.5 (take-up width of 83 +0.5/-1)
when the printer is shipped from the factory.
Note
Roll Holder Size
Paper Thickness
1” or 25.4 mm
65 to 100 µm
2” or 50.8 mm
100 to 150 µm
3” or 76.2 mm
100 to 150 µm
“The size of the core
used is related to the
thickness of the paper
used.”