Star Trac Pro S User Manual (English)

Other manuals for Star Trac Pro S

Questions and Answers:

M
Mark LewisAug 8, 2025
What to do if my Star Trac Pro S Treadmill displays 'EL STL' error?
- W
  Wesley FrazierAug 8, 2025
  If your Star Trac Treadmill's elevation system has malfunctioned, begin by engaging Motor Test Mode to check the elevation response and the corresponding LEDs on the MCB. If there's no LED activity or response from the elevation motor, the MCB might need replacing. Also, make sure there isn't anything blocking the elevation screws or belt. Binding elevation screws, possibly due to a lack of cleaning and lubrication, can also cause this issue. Finally, check that the elevation idler isn't loose or damaged, as this could lead to binding.
M
Mary WangAug 12, 2025
What to do if my Star Trac Treadmill displays 'NO SENSOR' error?
- P
  Patricia LittleAug 12, 2025
  If your Star Trac Treadmill displays 'NO SENSOR', it could be due to a sudden speed change detected by the RPM Sensor, a loss of speed feedback, or a loose cable. Start by engaging Motor Test Mode to check the speed response; no response indicates the RPM Sensor may need replacement. Then, check if the RPM Sensor LED on the MCB is responding; if not, the MCB may need replacing. Also, verify that the MIN SPD, ½ SPD, and MAX SPD are correctly set in Manager Mode. Finally, engage Speed Calibration; if calibration fails, the MCB may need replacement.
J
Justin TuckerAug 16, 2025
What to do if my Star Trac Pro S Treadmill displays 'SPEED CHG' error?
- J
  Jackie RobertsonAug 16, 2025
  If your Star Trac Treadmill displays 'SPEED CHG', this indicates a sudden speed change detected by the RPM Sensor or irregular speed at high or low speeds. First, engage Motor Test Mode to verify the speed response; no response suggests the RPM Sensor needs replacement. Also, check if the RPM Sensor LED on the MCB is responding; if not, replace the MCB. Verify that the MIN SPD, ½ SPD, and MAX SPD are correctly set in Manager Mode. Engage Speed Calibration; if it fails, replace the MCB. Lastly, ensure the motor brushes are secured within the motor.
B
Brandon DavisAug 20, 2025
What does 'EL LOST' mean on my Star Trac Pro S?