Installation
7
Receiving the Range
Upon receipt, check for freight damage, both visible and concealed.
Note visible damage on the freight bill at the time of delivery and require
the carrier's agent to sign the freight bill. Concealed loss or damage
means loss or damage, which does not become apparent until the
merchandise has been unpacked. If concealed loss or damage is
discovered upon unpacking, make a written request for inspection by
the carrier's agent within 15 days of delivery. Keep all packing material
for inspection. Do not return damaged merchandise to STAR
Manufacturing Company. File your claim with the carrier.
Location
Prior to un-crating, move the range as near its intended location as
practical. The crating will help protect the unit from the physical
damage normally associated with moving it through hallways and
doorways.
Un-crating
The range will arrive completely assembled inside a wood frame
covered by cardboard box and strapped to a skid. Remove the
cardboard cover, cut the straps and remove the wood frame.
RANGE WEIGHS 410 LBS (186 kilograms). FOR SAFE
HANDLING, INSTALLER SHOULD OBTAIN HELP AS
NEEDED, OR EMPLOY APPROPRIATE MATERIALS
HANDLING EQUIPMENT (SUCH AS A FORKLIFT,
DOLLY, OR PALLET JACK) TO REMOVE THE UNIT
FROM THE SKID AND MOVE IT TO THE PLACE OF
INSTALLATION.
CAUTION ANY STAND, COUNTER OR OTHER DEVICE ON WHICH
RANGE WILL BE LOCATED MUST BE DESIGNED TO
SUPPORT THE WEIGHT OF THE OVEN (410 LBS.).
SHIPPING STRAPS ARE UNDER TENSION AND CAN
SNAP BACK WHEN CUT.
Remove range from skid and place in intended location.
INSTALLING THE LEGS
Legs or Casters are available and must be specified upon ordering.
To install the 6-inch legs, remove the legs from the range packing,
place some cardboard on the floor and gently tip the range onto its
back. Fasten the legs into the threaded holes provided and then gently
flip the oven onto its legs.
To install the 6-inch casters, remove the casters from the oven cavity,
place some cardboard on the floor and gently tip the range onto its
back. Attach the casters to the adapter plates. Install the four adapter
plates (one in each corner with the flange pointed toward the oven).
Gently tip the oven onto its casters.
To Next Page
Loading...