Need help?Do you have a question about the Star SP712 Series and is the answer not in the manual?
General| Type | Impact Dot Matrix Printer |
|---|---|
| Print Method | Impact Dot Matrix |
| Interface | Serial, Parallel |
| Emulation | ESC/P |
| Weight | 2.9 kg |
Check all necessary accessories are included in the package after unpacking.
Connect appropriate interface cable (Parallel, RS-232, USB, Ethernet) to the PC's port.
Connect the interface cable to the printer's rear connector, using ferrite cores as needed.
Install printer driver and utility software from the supplied CD-ROM onto the Windows operating system.
Connect the power cord to the printer and a grounded AC outlet, ensuring voltage compatibility.
Turn the printer ON using the power switch; the POWER lamp should illuminate.
Turn off power, open cover, place cartridge, rotate feed knob, close cover to load ribbon.
Open cover, set paper roll correctly, pull edge, and close cover securely to load paper.
Lists recoverable and non-recoverable errors, their causes, and recovery conditions.
Steps to turn off power, open cover, remove jammed paper, and close cover.
Procedure to resolve issues with a locked or failed auto cutter.
To Next Page
