– 22 –
6-3. Errors
1) Recoverable error
Error Descrip-
tion
POWER lamp ERROR lamp Buzzer Recovery
Conditions
Paper end error On
Flashes (On: 1 sec./
Off: 1 sec.)
4 short beeps (0.13
sec.) repea ted
twice
*1
Printer cover open
error
On On Beep *2
Front cover open
error
Flashes (On: 0.5
sec./Off: 0.5 sec.)
On Beep *3
Paper near end
error
On Flashes (On: 2
sec./Off: 2 sec.)
None *4
Head high temper-
ature detection
Flashes (On: 1
sec./Off: 1 sec.)
Off None *5
Board high tem-
perature detec-
tion
Flashes (On: 2
sec./Off: 2 sec.)
Off None *6
Cutter error (on
models with cut-
ter)
On Flashes (On: 0.125
sec./Off: 0.125
sec.)
3 short beeps (0.13
sec. + 0.13 sec. +
0.5 sec.)
*7
Mechanical error
(other than cutter
error)
On Flashes (On: 0.25
sec . / O ff : 0.25
sec.)
2 short beeps (0.13
sec. + 0.5 sec.)
*8
Black mark detec-
tion error
On Flashes (On: 0.5
sec./Off: 0.5 sec.)
3 short beeps (0.13
sec. + 0.13 sec. +
0.13 sec.)
*9
*1 Automatically recovered by loading a new paper roll, then closing the printer cover.
*2 Automatically recovered by closing the printer cover.
*3 Automatically recovered by closing the front cover.
*4 Automatically recovered by loading a new paper roll, then closing the printer cover.
*5 Automatically the printer is recovered after the print head has cooled.
A print head temperature error is not abnormal.
*6 Automatically the printer is recovered after the board has cooled.
To Next Page
Loading...
