User manual
Controlling the System using
a Tag
Appearance
metka.png
Image not found or type unknown
metla_new.png
Image not found or type unknown
Checking Connection
To check the connection between the tag and the main unit, briefly press the tag button. If the
connection is established, the tag’s LED will flash twice; if not, it will flash once. The color of the
flash corresponds to the set mode:
Green — "antihijack by tag loss" mode is off.
Red — "antihijack by tag loss" mode is on.
Yellow — service mode.
System Control
Press durations for the tag button:
Short press — press and release the button, followed by a flash corresponding to the
current operating mode.
Long press — hold the button until LED flashes appear. The duration of the press can be
of two levels:
Additional Bluetooth remote tags (hereafter referred to as the tag), included in the package,
are initially in transport mode, in which they are disabled. Pressing the tag button in this
mode will be indicated by green, red, and yellow flashes of the built-in LED.
Before use, press the tag button several times until the flash color changes to green.
The availability of the tag depends on the configuration of the security system.
To Next Page
Loading...
