If the speed reading function is not supported, the algorithm is as follows:
One of the security zones (doors, hood, or trunk) is breached
The motion sensor is triggered
After 30 seconds, the system will start searching for the tag/remote key
After 30 seconds, if the tag/remote key is not detected, the system will activate warning
signals of the upcoming engine block with the siren and hazard lights for 10 seconds
The engine will be blocked either after 3 minutes or upon pressing the brake pedal
Exiting the "Anti-Hijack" mode by tag or remote key loss can be done in one of the following ways:
When the tag/remote key is within range
By SMS command 30 XXXX ,where XXXX is the emergency disarm code specified on the
plastic card or pin envelope of the owner
By entering the emergency disarm code specified on the plastic card or pin envelope of
the owner using the service button or transceiver button
From the personal account on the starline.online website. The emergency disarm code
specified on the plastic card or pin envelope of the owner needs to be entered.
«Slave» mode
The "Slave" mode allows controlling the system using the standard car alarm remote key.
When deactivating the standard alarm, the system will wait for owner authorization confirmation
through any of the methods described below, after which the car alarm will be disabled:
Presence of the remote key within the detection zone upon deactivation of the alarm. The
search time for the remote key is set from 15 to 60 seconds.
Presence of the tag within the detection zone upon deactivation of the alarm. The search
time for the tag is set from 15 to 60 seconds.
By entering the owner's authorization code using the standard car buttons (e.g.,
multimedia control buttons on the steering wheel, window control buttons). The code
entry is done with the ignition on. If the owner's authorization code is not entered, the
If the emergency disarm code is entered incorrectly 3 times, the ability to enter the code will
be blocked for 15 minutes, and the owner will receive an SMS notification.
By default, the "Anti-Hijack" by tag or remote key loss option is disabled. To enable it, hold
the tag button until a long red flash appears, then release the button.
The authorization time will be counted from the moment one of the doors, hood, or trunk is
opened.
To Next Page
Loading...
