The "Alarm" mode is activated.
The vehicle starts moving.
The hood is opened.
The parking brake is released (for MT vehicles).
The AT selector is shifted out of the "Park" position (for AT vehicles).
The brake pedal is pressed.
The engine reaches the maximum temperature threshold specified during the security
system setup to protect the engine from overheating.
Car driving continuation after remote engine starting
To continue driving the car, without stopping the engine after remote starting, do as follows:
for cars with ignition lock:
deactivate complex security;
insert the key into the ignition lock, turn it to position «Ignition on» and start moving;
the LED on the valet button will go out at movement start, pressing of the brake
pedal or parking brake release;
for cars with START/STOP button:
Several options are possible depending on the car and complex connection method:
first variant (*):
deactivate complex security;
hold the brake pedal for 3 seconds;
the LED on the service button will go out, after which movement can be started (the
START/STOP button need not be pressed);
second variant (*):
deactivate complex security;
press the START/STOP button 1 or 2 times (*);
the LED on the service button will go out, after which movement can be started.
Function «Engine starting preheater»
The function allows for engine preheating before starting. The starting preheater can be controlled
both in the manual and automatic mode.
Manual mode
In the manual mode the starting preheater is switched on/off by a command.
(*) Ask the installation specialist during mounting about the connection method of your
complex and the operation algorithm.
To Next Page
Loading...
