To Next PageTo Next Page
Need help?Do you have a question about the Starrett 3752 Series and is the answer not in the manual?
General| Brand | Starrett |
|---|---|
| Model | 3752 Series |
| Category | Measuring Instruments |
| Language | English |
Displays measurements in large characters on an LCD with up to six digits and four decimal places (inch) or two (mm).
Enables users to pre-assign any reading to the display at any slide position for quick setup.
Allows setting minimum and maximum tolerance limits for pass/fail criteria and automated quality screening.
Lets users set the display to zero at any slide position, useful for measuring differences between features.
Displays only negative values with a sign and allows use as a comparator for deviations from zero.
Enables direct conversion between inch and millimeter modes at any position without changing the zero reference.
Retains the displayed measurement regardless of slide movement, allowing reading when not positioned for easy viewing.
Displays 'ERR04' when the slide moves too fast, preventing incorrect readings.
The display turns off after 30 minutes of inactivity but reactivates with no loss of position reading upon movement.
Features a well-balanced, hardened, ground, and lapped base with finger grooves for stability.
Instructions on cleaning the gage and surface plate, and activating the measuring mode.
Steps to set a zero reference point using a test indicator on a surface plate, gage block, or part.
Procedure for measuring the height of a surface using the indicator and fine adjustment mechanism.
Guidance on mounting and using the scriber for setting zero reference or marking surfaces.
Step-by-step guide for installing two CR2450 batteries into the height gage.
How to turn the display on or off without losing the current position reading.
Reverses the sign of the display reading (positive/negative) for upward or downward movement.
Freezes the displayed measurement, retaining the zero reference position until the button is pressed again.
Allows switching between inch and millimeter measurement modes with a single button press.
Short press zeros the display (incremental mode); long press returns to original reading (absolute mode).
Changes the functions of other buttons, enabling SET, PRESET, and LIMITS modes.
Procedure to set minimum and maximum tolerance limits for pass/fail indication.
Manual setting of any desired reading into the display at any slide position.
Details the available measuring ranges for 12" and 24" models in inches and millimeters.
Provides the accuracy tolerance for 12" and 24" models in inches and millimeters.
States the smallest measurable increment for the height gage.
Specifies the battery type (CR2450) and expected battery life.
Recommendations for temperature, dust, and humidity to ensure optimal performance and longevity.
Emphasizes the need for care to avoid bumping or dropping the precision instrument.
Instructions for cleaning the vertical bar with a lint-free cloth and applying light lubricant.
Details serial data transmission format (baud rate, bits) and required cables for data collection.
Checklist for common problems like 'Does not count' or 'Error Display' and their potential causes.
Instructions for returning the instrument for repair, including contact details and required documentation.
