Emergency Stop Switch
•
If the Emergency Stop is engaged while a program is running, all motion will cease, and a
dialog box will display the following message:
“The program has been interrupted [SIC] by a hardware error? A CNC E-Stop error
occurred. An E-Stop Error occurred on axis 1. An E-Stop Error occurred on axis 2. An E-
Stop Error occurred on axis 3. “
When the Emergency Stop is disengaged, nothing further will happen. The system should
now resume normal function and the program will need to be re-run from the start. Any data
collected before the Emergency stop was engaged will be saved and can be viewed/exported
as normal.
•
If the user attempts to run the program with the Emergency Stop engaged, all motion will
cease, and a dialog box will display the following message:
“The program has been interrupted [SIC] by a hardware error? A CNC E-Stop error
occurred. An E-Stop Error occurred on axis 1. An E-Stop Error occurred on axis 2. An E-
Stop Error occurred on axis 3. “
When the Emergency Stop is disengaged, nothing further will happen. The system should
now resume normal function.
To Next Page
Loading...
Need help?
General