Startec S.R.L. Rain Speed 060 - Page 5

R
RR
A
AA
I
II
N
NN
0
00
6
66
0
00 Operating features
4
METRES unrolled pipe key
- SHORT pressure
- Displays the amount of metres of unrolled pipe.
- LONG pressure
- Enables programming the metres of unrolled pipe
(the symbol * on the left side of the display shows the beginning of the
programming process). To introduce changes use Speed keys _+_ or
_-_.
- At switch on, it allows setting up the clock.
- Simultaneous pressure of
the IRRIGATION TIME key
- Enters TEST mode (MANUALLY)
NOTE: in this manual it is referred to by using the symbol _m_
IRRIGATION TIME key
- SHORT pressure
- Displays irrigation time expressed in hh:mm (hours and minutes), or, if the
clock is set up in: day of the week, hours and minutes.
- LONG pressure - Enables programming the irrigation time (the symbol * on the left side of the
display shows the beginning of the programming process).
- To introduce changes use Speed keys (>) _+_ or _-_
- Simultaneous pressure
of the METRES unrolled
pipe key:
- Accesses TEST mode. (MANUALLY)
NOTE: in this manual it is referred to by using the symbol _h_
SPEED key +
- SHORT pressure - Displays the programmed SPEED expressed in metres/hour (m/h).
- In SPEED programming mode, single m/h increase.
- In METRES unrolled pipe programming mode, single metre increase.
- In IRRIGATION TIME programming mode, time increase. Useful to know the
retraction speed to at which the irrigator should work to finish at a
programmed hour.
- LONG pressure
- Enables programming the SPEED at which irrigation is programmed (the
symbol * on the left side of the display shows the beginning of the
programming process).
- CONTINUOUS
pressure
- In SPEED programming mode, fast m/h increase.
- In METRES programming mode, fast metre increase.
- In IRRIGATION TIME programming mode, fast time increase.