5
Keyboard Hotkey Command Reference Chart
Command
Name
Hotkey Sequence Description
Select active
computer
[ScrLk]+[ScrLk]+[x]
Switches access to the computer connected to the
corresponding port number on the KVM. ([x]= a
number on the keyboard)
Bind computer
and Audio/Mic
control (default)
[ScrLk]+[ScrLk]+[Q]
When either the select active computer or select
audio/mic output control commands are executed,
both functions are switched to the selected port.
Unbind
computer and
Audio/Mic
output control
[ScrLk]+[ScrLk]+[W]
The computer control and USB hub control can be
executed separately; KVM control and Audio/Mic
output control control can be assigned to dierent
ports at one time.
Select next/
previous port
[ScrLk]+[ScrLk]+[arrow]
Selects the next (up arrow key) or previous (down
arrow key) numbered port for control.
Select previous
port
[ScrLk]+[ScrLk]+[BkSp] Selects the most recent previously active port.
Beep sound
on/o
[ScrLk]+[ScrLk]+[B] Enables/disables audible responses from the KVM.
Dene new
hotkey sequence
[ScrLk]+[ScrLk]+[H]+[y]
Change the standard [ScrLk] hotkey to a new value
(see below).
Autoscan [ScrLk]+[ScrLk]+[S]
Automatically switch active ports in sequence
every 10 seconds. (Press any key to cancel.)
Autoscan with
programmable
delay
[ScrLk]+[ScrLk]+[S]+[z]
Autoscan with a delay other than 10 seconds (see
below). Press any key to cancel.
To Next Page
Loading...
Need help?
General
